Trouble Shooting; Fault Messages - Bosch VBC5580S0 Instruction Manual

Trouble shooting

en
3Trouble shooting
T r o u b l e s h o o t i n g
Fault
The appliance does not work
The appliance cannot be started
‚ƒ : ‹‹ is flashing on the display
The interior lighting is not working
All food that is cooked in the oven
burns within an extremely short
period of time.
Door panels are steamed up.
Although the appliance is switched
on, it cannot be operated; the
D symbol is shown on the display
--------

Fault messages

If a fault message beginning with
display, set the function selector to "Off". If the fault
message does not disappear, please contact our after-
sales service.
Fault message
"§§‚
"§§ƒ
"§§...
"§§†
"§§‡
"§§‰
--------
20
Possible cause
The plug is not plugged into the mains
Power cut
The circuit breaker is faulty
The appliance door is not fully closed
The appliance is not switched off
Power failure
Gentle top/bottom heating mode is active
The bulb is faulty
Thermostat faulty.
This is normal and results from differences in temper-
ature.
The childproof lock is activated.
"§§ appears on the
Possible cause
Temperature sensor failed.
The temperature in the cooking compartment is too
high.
Door locking mechanism incorrectly activated.
Fan heating element faulty or not connected.
Motor faulty or not connected.
Cooling fan faulty or not connected.
Notes/remedy
Connect the appliance to the power supply
Check whether other kitchen appliances are working
Check in the fuse box to make sure that the fuse for
the appliance is OK
Close the appliance door
Switch the appliance off and back on again
Reset the clock.
In gentle top/bottom heating mode, the interior light-
ing is not switched on.
Replace the bulb.
Call the after-sales service.
Heat the appliance up to 100 °C and then switch it
back off after 5 minutes.
Press and hold the ] touch button until the
D symbol goes out.
Information/remedy
Call the after-sales service.
Call the after-sales service.
Call the after-sales service.
Call the after-sales service.
Call the after-sales service.
Call the after-sales service.