Table of Contents
Advertisement
Fault
The drying time is too
long.
Water is leaking from
the appliance.
The laundry is too
damp.
Cause and troubleshooting
Clean the heat exchanger.
2.
→ "Cleaning the base unit", Page 36
→ "Closing the base unit", Page 36.
3.
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
The seal for the heat exchanger cover is dirty.
Clean the seal for the heat exchanger cover.
▶
→ "Cleaning the filter system on the base unit",
Page 32
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
→ "Connecting the water drain hose", Page 14
The lever for the heat exchanger cover is not closed
correctly.
Ensure that the lever for the heat exchanger cover
▶
is closed correctly.
→ "Closing the base unit", Page 36
Unsuitable programme for the type of fabric.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 26
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
The load is too large.
Observe the maximum load capacity of the
▶
→ "Programmes", Page 26.
After the end of the programme, warm laundry feels
damper than it actually is.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Unsuitable dryness level set.
→ "Changing the dryness level", Page 25.
▶
Drying target not adjusted.
→ "Adjusting the dryness level", Page 25.
▶
Load too small.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 26
Moisture sensor dirty.
Troubleshooting en
41
Advertisement
Table of Contents
