Troubleshooting - Electrolux EGG3322NVX User Manual

28 www.electrolux.com
as chlorides, do not clean the surface
with disinfectants, stain or rust
removers and immersion cleaners.
6.2 Pan supports
The pan supports are not
resistant to washing in a
dishwasher. They must be
washed by hand.
1. Remove the pan supports to easily
clean the hob.
Be very careful when
you replace the pan
supports to prevent the
hob top from damage.
2. The enamel coating occasionally can
have rough edges, so be careful
when you wash the pan supports by
hand and dry them. If necessary,
remove stubborn stains with a paste
cleaner.
3. After you clean the pan supports,
make sure that they are in correct
positions.
4. For the burner to operate correctly,
make sure that the arms of the pan
supports are aligned with the centre
of the burner.
6.3 Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, sugar and food with sugar.

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
There is no spark when
you try to activate the
spark generator.
If not, the dirt can cause damage to
the hob. Take care to avoid burns.
• Remove when the hob is
sufficiently cool: limescale rings,
water rings, fat stains, shiny metallic
discoloration. Clean the hob with a
moist cloth and non-abrasive
detergent. After cleaning, wipe the
hob dry with a soft cloth.
• To clean the enamelled parts, cap
and crown, wash them with warm
soapy water and dry them carefully
before you put them back on.
6.4 Cleaning the spark plug
This feature is obtained through a
ceramic ignition candle with a metal
electrode. Keep these components well
clean to prevent difficult lighting and
check that the burner crown holes are
not obstructed.
6.5 Periodic maintenance
Speak to your local Authorised Service
Centre periodically to check the
conditions of the gas supply pipe and the
pressure adjuster, if fitted.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
Remedy
Check if the hob is correct‐
ly connected to the electri‐
cal supply.