30" (762 mm) ELECTRIC RANGE INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Clearances and Dimensions
1. Provide adequate clearances between the range and adjacent combustible surfaces.
2. Location—Check location where the range will be installed. Check for proper electrical supply, and the stability
of the floor.
3. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must
be solid and level.
FRONT
VIEW
30"
(762 mm)
Minimum
Minimum to wall
1"
on either side of
(25 mm)
range above
36'' (914 mm)
height.
36"
(914 mm)
(762 mm)
RANGE
OVERALL
DIMENSIONS
48"
(1219 mm)
Maximum
49"
(1245 mm)
Maximum
Door Open
*30" (762 mm) MINIMUM CLEARANCE BETWEEN THE TOP OF THE COOKING SURFACE AND THE BOTTOM OF AN UNPROTECTED
WOOD OR METAL CABINET; OR 24" (610 mm) MINIMUM WHEN BOTTOM OF WOOD OR METAL CABINET IS PROTECTED BY NOT
LESS THAN 1/4" (6 mm) FLAME RETARDANT MILLBOARD COVERED WITH NOT LESS THAN NO. 28 MSG SHEET STEEL, 0.015"
(0.4 mm) STAINLESS STEEL, 0.024" (0.6 mm) ALUMINUM OR 0.020" (0.5 mm) COPPER. 0" (0 mm) CLEARANCE IS THE MINIMUM FOR
THE REAR OF THE RANGE. FOLLOW ALL DIMENSION REQUIREMENTS PROVIDED ABOVE TO PREVENT PROPERTY DAMAGE,
POTENTIAL FIRE HAZARD, AND INCORRECT COUNTERTOP AND CABINET CUTS.
TO ELIMINATE THE RISK OF BURNS OR FIRE BY REACHING OVER HEATED SURFACE UNITS, CABINET STORAGE SPACE
LOCATED ABOVE THE SURFACE UNITS SHOULD BE AVOIDED. IF CABINET STORAGE IS TO BE PROVIDED, THE RISK CAN
BE REDUCED BY INSTALLING A RANGE HOOD THAT PROJECTS HORIZONTALLY A MINIMUM OF 5" (127 mm) BEYOND THE
BOTTOM OF THE CABINETS.
P/N 316259203 REV C (1409)
(For 4 Wire, 60 Hz. Systems)
30"
(762 mm)
Minimum to
cabinets on
18"
either side of
(457 mm)
range.
30"
0" (0 mm) clearance below cooking top and at rear of range.
25- 3/4"
30"
(654 mm)
(762 mm)
(940 mm)
29- 7/8"
(759 mm)
SIDE
VIEW
13"
330 mm
Maximum depth
for cabinets
above range top.
25"
635 mm
36
1/8"
(3 mm)
2-5/8" (67 mm) for models
equipped with warmer drawers
3-1/2" (89 mm) for models
equipped with storage drawers
1
Centerline of
range
All dimensions for electrical outlet location
are maximum.
Dashed cubed area
shows where the electrical outlet must be
installed
for flush to the wall installation.
11"
(279 mm)
22"
(559 mm)
6"
(152 mm)
Wall
Edge
English - Pages 1-4
Français - Pages 5-8