Audio Pro Sub Supreme User Manual page 4

3. FUNCTIONS
Power switch (8):
To switch the subwoofer amplifier to ON or OFF
mode. Make sure it is turned OFF during installation.
Turn OFF the subwoofer when it will not be used for a
longer period of time.
Standby switch (2):
In Auto mode: The amplifier goes automatically into
standby mode if no signal been detected in 20 minu-
tes. If goes on automatically if signal is detected.
In ON mode: The amplifier will be constantly ON.
Main Power indicator: (9)
The red indicator shows the operation status of the
subwoofer. Red light - subwoofer is on or in standby
mode.
Power indicator: (Blue on front)
The blue indicator shows the operation status. Blue
light - the subwoofer is on.
*
(Use the enclosed Y-adaptor)
5
4
3
2
1
*
6
7
9
8
LEVEL
MIN MAX
LOW PASS
FREQUENCY
50HZ 100HZ
PHASE 180 0 0
ON AUTO
L
LINE IN
R
IN
SPEAKER
R L
LEVEL
OUT
DOUBLE INSULATION - when servicing
use only identical replacement parts.
POWER ON OFF
Volume control (5):
The sound level of the subwoofer can be adjusted.
Use the Level control carefully, remember that
program material may contain very high energy.
LowPass (4):
The Lowpass crossover frequency can be adjusted
variably between 50 and 100Hz. This gives you a
unique possibility to perfectly match the Subwoofer to
your satellite speakers. The lowest frequencies will be
reproduced only by the subwoofer.
Phase adjustment (3):
The placement of the subwoofer can have effect on
the phase between subwoofer and satellites. With the
phase adjustment the phase can be switched 180
degrees.
CAUTION
SUB SUPREME
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING:SHOCK HAZARD-DO NOT OPEN.
AC 230V 50Hz 200W AVIS:RISQUE DE CHOC ELECTRIQUE-NE
PAS OUVRIR.
Serial no:
CAUTION:
TO REDUCE THE RISK OF FIRE,
REPLACE WITH ONLY THE SAME
TYPE AND RATING OF FUSE.
ATTENTION:
FUSE TYPE:
UTILISER UN FUSIBLE DE
T1AL 250V FOR 230V
RECHANGE DE MEME TYPE.
4
10
11