Primary Master (Sub-Menu) - Asus S82A User Manual

Primary Master (sub-menu)

This field is used to configure the IDE Hard Disk installed in the system. To configure a hard disk drive,
move the cursor to highlight the Primary Master field and press the Enter key to enter the sub-menu.
Type:
Multi-Sector Transfers:
LBA Mode Control:
32 Bit I/O:
Transfer Mode:
Ultra DMA Mode:
NOTE: Before attempting to configure a hard disk drive, make sure you have the con-
figuration information supplied by the manufacturer of the drive. Incorrect settings
may cause your system to not recognize the installed hard disk. To allow the BIOS to
detect the drive type automatically, select [AUTO].
Type: [Auto] (Use the "-" or "Shift +" key to change setting)
Select Auto to automatically detect an IDE type drive. This option only works with standard built-in
IDE drives. If automatic detection is successful, the correct values will be filled in for the remaining
fields on this sub-menu.
To configure a drive manually, select User. Manually enter the number of cylinders, heads and sectors
per track for your drive. Refer to your drive documentation or look on the drive for this information. If
no drive is installed or if you are removing a drive and not replacing it, select None. Set the type to CD-
ROM to support a CD-ROM or DVD-ROM drive.
Cylinders:
This field configures the number of cylinders. Refer to your drive documentation to determine the correct
value to enter into this field. NOTE: To make changes to this field, the Type field must be set to User.
Heads:
This field configures the number of read/write heads. Refer to your drive documentation to determine the
correct value to enter into this field. NOTE: To make changes to this field, the Type field must be set to User.
Primary Master [IBM-DJSA-220-(PM)]
[Auto]
[16 Sectors]
[Enabled]
[Enabled]
[FPIO 4 / DMA 2]
[Disabled]
5. Configuring the BIOS
Item Specific Help
User = you enter
parameters of hard-disk
drive installed at this
connection.
Auto = autotypes
hard-disk drive
installed here.
None = force setting no
IDE device.
CD-ROM = a CD-ROM drive
is installed here.
67