Table of Contents
Advertisement
Fault
Slurping, rhythmical suction
noise.
Problem with results
Fault
Creasing.
Detergent or fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
The spin result is not satis-
factory. The laundry is too
wet/too damp.
Cause
The drain pump is active, the
detergent solution is
pumped out.
Cause
The spin speed is too high.
The load is too large.
The wrong programme is se-
lected for the type of fabric.
Too much detergent/fabric
softener in the detergent
drawer.
A low spin speed is selected.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
Unbalance load detection
system is using a reduced
spin speed to eliminate an
unbalance.
Troubleshooting en
troubleshooting
Not a fault – normal operating
▶
noise.
troubleshooting
The next time you run a wash cycle,
▶
set a lower spin speed.
The next time you run a wash cycle,
▶
reduce the amount of laundry being
loaded.
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 30
When dosing liquid detergent and
▶
fabric softener, observe the mark-
ing in the detergent drawer and do
not dose above this.
The next time you run a wash cycle,
▶
set a higher spin speed.
Start the Spin programme.
▶
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Spin programme.
▶
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
59
Advertisement
Table of Contents
