Cancelling The Programme; Salt Indicator ( ); Rinse Aid Indicator ( ); Adjusting The Amount Of Rinse Aid - Beko DIN48Q20 User Manual

Operating the product
C
Your machine performs water
softening depending on the
hardness level of the supply
water. Washing time can
change while the programme
is running depending on the
ambient temperature where
your machine is installed,
temperature of the supply water
and amount of the dishes.
C
Pay attention not to open the
door of the machine when it is
running. There may be a rush of
vapour when you open the door
of your machine; be careful.
C
The machine will remain silent
in pause mode for some time
in order to remove the water
from the machine and on the
dishes completely and to have
the water softener cleaned, and
then it will resume running in
drying mode.

Cancelling the programme

Open the door of the product Press and
hold the Programme Selection / Programme
Cancel keys for 3 seconds. After the 3 - 2 - 1
countdown, 0:01 is displayed, close the door
of the product and wait for the draining
process complete. Draining is completed in
2 minutes and the machine gives an audible
warning when it is completed.
C
There might be residues of
detergent or rinse aid in the
machine and/or on the pieces
being washed depending on the
step the programme you have
cancelled was in.
Dishwasher / User's Manual

Salt indicator ( )

Please check the salt indicator on the display
to see whether there is adequate amount
of softening salt in the dishwasher or not.
You need to refill the salt reservoir with
salt whenever salt indicator appears on the
display of your machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.

Rinse Aid indicator ( )

Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.
Adjusting the amount of
rinse aid
1. After switching on your machine, press
the Menu key for 1 second.
2. Using <- and +> keys, proceed to "P:" on
the display.
3. Set to the appropriate level with the
Selection key.
4. Press the Menu key to exit the settings
menu. Your setting will be saved
automatically.
No rinse aid dispensed in P:0 wash position.
1 dose of rinse aid is dispensed in P:1
position.
2 doses of rinse aid are dispensed in P:2
position.
3 doses of rinse aid are dispensed in P:3
position.
4 doses of rinse aid are dispensed in P:4
position.
29 / 45 EN