Wyrestorm NHD-000-RACK4 Quick Start Manual

6U/12 Slot Rack Mount for NetworkHD™ 100/200/400 Series
NHD-000-RACK4
The NHD-000-RACK4 is a 6U rack mount that provides a clean installation for up to 12 NetworkHD
NetworkHD Controller and Enado Mini.
WyreStorm recommends reading through this document in its entirety to become familiar with the product's features before beginning the installation
process.
In the Box
1x NHD-000-RACK4 Chassis
2x 19" Rack Mounting Bracket
7x Blank Plate
1x Assembly Screws Pack
Dimensions and Weight
Dimensions and Weight
Rack Units/Wall Box
Height With | Without Feet
Width With | Without Brackets
Depth With | Without Handles
Weight (Chassis without Plates)
Note: WyreStorm reserves the right to change product specification, appearance or dimensions of this product at any time without prior notice.
Copyright © 2018 WyreStorm Technologies |
NHD-000-RACK4 Quickstart Guide | 180718
6U
265.9mm/10.47in | 265.9mm/10.47in
483mm/19.02in | 440mm/17.33in
188.3mm/7.42in | 150mm/5.91in
2.3kg/5.06lbs
wyrestorm.com
100, 200 and 400 Series encoders and decoders,
TM
Installing Chassis in a Rack
1. Attach the rack ears to both sides of the chassis using the supplied screws.
2. Position and install the assembly into the rack and secure with rack screws
(not supplied).
Tip: To keep the installed devices within operating temperature, do not
position the NHD-000-RACK4 directly above heat generating devices such as
amplifiers.
Installing Devices into the Chassis
1. Install the devices into the chassis using the supplied screws and
mounting plates.
2. Install the supplied blank plates using the supplied screws to cover any
open slots in the chassis.
3. If not installing in a rack, place the assembled chassis on a solid flat
surface such as a cabinet or shelf located in a dry, well ventilated area.
4. Connect the devices per their specific documentation.
UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973)
Quickstart Guide
support@wyrestorm.com