Wyrestorm NHD-140-RACK-1U Quick Start Manual

1U / 2 Slot Rack Mount for NHD-140-TX
NHD-140-RACK-1U
The NHD-140-RACK-1U is a 1U rack mount that provides a clean installation for up to 2 NetworkHD™ NHD-140-TX encoders.
WyreStorm recommends reading through this document in its entirety to become familiar with the product's features before beginning the installation
process.
In the Box
1x NHD-140-RACK-1U Chassis
4x Encoder Mounting Bracket
1x Blanking Plate
1x Assembly Screws Pack
Installing Chassis in a Rack
1. Attach the mounting brackets to the sides of the NHD-140-TX
encoder(s) using the supplied screws.
2. Position the NHD-140-TX encoder(s) through the NHD-140-RACK-1U
front face cutout(s) so that the front or rear face of the encoder(s) is
flush with the front face of the NHD-140-RACK-1U.
Copyright © 2019 WyreStorm Technologies |
NHD-140-RACK-1U Quickstart Guide | 190111
wyrestorm.com
3. Attach the NHD-140-TX encoder(s) to the NHD-140-RACK-1U main shelf
using the supplied screws.
4. Install the blanking plate (if required) using the provided screws
5. Position and install the assembly into the rack and secure with rack
screws (not supplied).
Tip: To keep the installed devices within operating temperature, do not
position the rack directly above heat generating devices such as amplifiers.
UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973)
1 of 2
Quickstart Guide
Secure with Screws
support@wyrestorm.com