Changing Effect Settings - Alesis 4 Reference Manual

Changing Effect Settings

When you dial up a Program, its Configuration is shown in the display to the right of
the Program's name.
RoomVerb REAL ROOM
The Configuration will either be a single reverb type effect (as in the example above),
or a combination of two or three effects (like Reverb+Delay, or Chorus>Delay>
Reverb). Once you have identified what effects are used in the Program's
Configuration, you can then find the effect parameters more easily.
To edit a Program's effect settings, you must first enter Edit mode. This is done by
pressing either the [PAGE] button or any one of the [A], [B], [C] or [D] buttons, as
long as the [PROG] button is lit (Note: Pressing these buttons in other modes
performs different functions). Once in Edit mode, the display will look something
like this:
1
01
Page Numbers
up to four pages available in Edit mode. In this example, only three
pages are available.
Selected Page
a box around its number. In this example, page 1 is currently
selected. Each time you press the [PAGE] button, the display will
advance to the next page.
Parameter Name Strip
four parameters. whose names will appear at the top of the display,
above their value settings.
Parameter Values and Bar Graphs
with both a numerical value and a bargraph. As you adjust a
parameter, both its numerical value and bargraph will change in
relation to the [VALUE] knob's position. The type of units a parameter
uses will be shown as well (dB, mSec, kHz, etc.).
A, B, C, D and EDITED Indicators. Each parameter in the selected page is
designated by a letter (A, B, C or D), which indicates which button ([A], [B], [C]
or [D]) should be pressed to select the desired parameter for editing. Once a
parameter has been edited, the word "EDITED" will appear below it.
MidiVerb 4 Reference Manual
Your First Session with the MIDIVerb 4 – Chapter 1
3
Decay
PRESET
80
A
L
PAGE 1 2 3
2
. Depending on the Configuration, there will be
. The currently selected page will be indicated by
. Each page in Edit mode contains up to
4
LPF PDly
22.8 150
B EDITED C
R
. Each parameter is shown
PMix
000
D
5
11