Starting The Programme; Childproof Lock; Adding/Removing Laundry; Changing The Programme - Siemens WN44G290GB Instruction Manual And Installation Instructions

Operating the appliance
en

Starting the programme

Touch and hold Start Reload button for
1~2 seconds, then release the button.
The programme starts and the
appliance door is locked.
The finish-in time is shown in the display
panel and counts down until the
programme starts. After the programme
has started, the programme duration is
displayed. And the symbols for the
programme progress are lighting up.

Childproof lock

You can lock the appliance to prevent
the settings you have set from being
changed inadvertently. To do this,
activate the childproof lock.
To activate the childproof lock:
After the programme starts, Touch and
hold the varioSpeed and Ready in/
Time Dry buttons for 3 seconds. The
symbol w lights up in the display
panel.
w lights up: The childproof lock is
■
activated.
w flashes: If the programme and
■
programme settings are adjusted
while childproof lock is activated.
When the programme ends, "Ÿš
Note:
is displayed. The door is unlocked. w
symbol remain on to remind you to
deactivate the childproof lock.
To deactivate the childproof lock:
Touch and hold the varioSpeed and
Ready in/Time Dry buttons until the
symbol w disappears.
38

Adding/removing laundry

After starting the programme (only for
washing), you can add or remove
laundry if necessary.
Touch the Start Reload button. The
appliance checks whether reloading is
possible.
If the following appears on the display
panel:
The symbol Õ disappears,
■
reloading is possible.
The symbol Õ lights up, reloading is
■
not possible.
To continue the programme, touch the
Start Reload button. The programme
continues automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the Start Reload button.
1.
Select another programme.
2.
And touch the Start Reload button
3.
again. The new programme starts
from the beginning.
If drying is activated, after
Note:
touching the Start Reload button, when
the •©£ is displayed, waiting for the
appliance running to cool down the
laundry till the •©£ disappears, then
select another programme.