Table of Contents
Advertisement
is first time Q&A mode configuration for the AP, you should assert the checkbox of "First Time
Configuration", and then select the question to answer. You could input any answer as you
like, but you should remember which question and answer you set for the other client
configuration.
After answer is set and "Next" button is clicked, utility program will start to search EasyConfig
AP with Q&A mode enabled. Then, the scan result will be shown as Figure-3. Click checkbox
of AP you want to associate with and click "Next" button, it will link to AP and exchange the
setting automatically as shown in Figure-6. After it is done, you may see a successful message
as shown in Figure-7.
8186 Infrastructure-Client Operation
You may set WLAN AP as an infrastructure client in Basic setting page of web server. Then,
go to EasyConfig page, you may see a figure shown in below:
Figure 7
After EasyConfig is enabled, you may select which method to use (Button or Q&A). If Button
mode is selected, user could push an EasyConfig button on 8186 evaluation board for 4-5
seconds. Then, EasyConfig LED will begin to blink. This operation is the same as in AP mode.
If any EasyConfig AP is ready (AP EasyConfig LED is blinking) and found, the 8186 client will
automatically negotiate the security policy with EasyConfig AP and adopt the setting when
46
Advertisement
Table of Contents
