Mitsubishi Electric MSZ-LN18VGW-E1 Service Manual page 48

Fixing the indoor coil thermistor
There are 2 forms of parts for fixing the indoor coil thermistor.
Clip shape
Position and procedure for mounting the clip-shape part
1. Set the indoor coil
thermistor in the center
of the clip-shape part.
NOTE:
Take care to avoid loss and accidental falling of the clip-shape part inside the unit.
Mount the clip-shape part on the marked position.
Do not pull the lead wire when removing the indoor coil thermistor.
© Copyright 2016 MITSUBISHI ELECTRIC CORPORATION
Issued: Mar. 2018. No. OBH766 REVISED EDITION-B
Issued: Sep. 2017. No. OBH766 REVISED EDITION-A
Published: Dec. 2016. No. OBH766
Made in Japan
Holder shape
HEAD OFFICE: TOKYO BUILDING, 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
When fixing the indoor coil thermistor
to the clip-shape/holder-shape part, the
lead wire should point down.
About the
same length
2. Check the (marked)
mounting position.
Specifications are subject to change without notice.
48
3.Mount the
clip-shape part.