Chamberlain Security+ 963D Owner's Manual page 2

The Remote Control Batteries
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with
3V2016 or 3V2450
• Do NOT recharge, disassemble, heat above 212°F (100°C) or
incinerate.
The 3V2016 lithium batteries for the opener and LED lights
(marked "LED and Opener Battery") should last 5 years. The
3V2450 lithium battery for the proximity lighting (marked
"Proximity Battery") should last 1-2 years.
To replace the batteries, remove the two screws and open the
remote control housing. Push the battery out of the holder for
removal. Insert replacement batteries positive side up (+).
Dispose of old batteries properly.
Replace the batteries with only 3V2016 or 3V2450 coin cell
batteries.
CAUTION: Do not bend spring contact. If bent, the proximity
sensor will not work.
LED and
Opener
Batteries
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the
battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
114A3566
coin batteries.
Proximity
Battery
Spring
Contact
©2007, Chamberlain Group Inc.
All Rights Reserved
Troubleshooting
PROBLEM
Reduced proximity
sensing (does not
activate by touching
top of remote control)
Dim LED lights
No rapid LED blinking
after pressing a button
Replacement Parts
PART NO. DESCRIPTION
10A19 3V2016 Lithium Battery: LED and Opener
10A33 3V2450 Lithium Battery: Proximity Switch
29C151 Visor Clip
FOR SERVICE, DIAL OUR TOLL FREE NUMBER:
1-800-528-9131
SOLUTION
Check if proximity lighting is disabled
by pressing a button.
The Proximity Sensor may be
oversensitized. Sit remote control
undisturbed for 60 seconds on a
non-metallic surface. This allows the
sensor to recalibrate itself.
Replace 3V2450 battery with same
type 3V2450 coin cell.
Replace two 3V2016 batteries with
same type 3V2016 coin cells.
Replace two 3V2016 batteries with
same type 3V2016 coin cells.
QTY
2
1
1