Caring For Your Dryer - LG TD-C9011A Owner's Manual

C
aring For Your Dryer
Clean lint filter
To maintain proper air flow and keep your dryer
operating a peak efficiency, it is important to empty
the lint filter between every load. If the CLEAN
FILTER light comes on during a cycle and the
beeper sounds, pause the dryer and empty the filter
immediately.
1. Open the door.
2. Pull the filter out.
3. Open the filter and
use your fingers to roll
the lint off the screen
surfaces. If the lint is
difficult to remove or
the filter material is
showing signs of
clogging, follow the
cleaning instructions
below.
4. Snap the filter closed
and replace it in the
dryer.
- Push the filter all the
way down to avoid
Interference with the
door
5. Close the door.
Wash the lint screen in warm, soapy, water.
Dry thoroughly and replace.
Clean lint filter during a cycle
If the CLEAN FILTER light flashes and the alarm
sounds during operation, clean the filter promptly.
1. Press the POWER button to stop the dryer. The press
it again to turn the dryer on.
2. Turn the CYCLE SELECTOR to select the
COOL AIR cycle.
3. Press the START/PAUSE button the start the dryer.
4. Let the COOL AIR cycle run for 5 minutes to cool the
dryer, then open the door and clean the lint filter.
Note
If the dryer is stopped in the middle of a
cycle, the lint filter may be very hot.
Failure to follow these cool down
instructions could result in injury.
Empty water container
If your dryer is not connected to a household drain,
then the water reservoir will capture the water from
the drying process. This should be emptied every
load. Failure to do so may result in poor drying
performance.
If the container becomes full during a cycle, the
EMPTY WATER light and alarm will be activated.
In this case, the water reservoir should be emptied
immediately, but in no case should it continue to be
used for more than 1 hour.
1. Using the
handle on the
front of the
drawer, pull out
the reservoir.
2. Using the
handle on the
front of the
drawer, pull out
the reservoir.
3. Drain the water into a sink.
4. Press the START/PAUSE button to resume
the cycle.
F
19