Setting The Sleep Timer; Displaying Tv Status Information; Understanding The Auto Power Off Feature; Understanding The Last Mode Memory Feature - Toshiba 32DT1U Owner's Manual

Setting the sleep timer

You can set the sleep timer to turn off the TV after a
set length of time (maximum of 180 minutes).
To set the sleep timer using the remote control:
Press on the remote control to set the length of
time until the TV turns off. Repeatedly press
increase the time in 10-minute increments, or press
p or q to increase or decrease the time in 10-minute
increments, to a maximum of 180 minutes.
To set the sleep timer using the on-screen
menus:
1無
Press and open the Setup menu.
2無
Highlight Sleep Timer and press
3無
Press the Number buttons to enter the length of
time in 10-minute increments.
4無
Highlight Done and press
Note: When a power failure occurs, the
sleep timer setting may be cleared.
To display the remaining sleep time:
Press .
Note: A message will display on-screen when
there is one minute remaining on the sleep timer.
To cancel the sleep timer:
Repeatedly press until it is set to 0 minute.

Displaying TV status information

To display TV status information using
RECALL:
Press on the remote control.
The following information will display (if applicable):
Current input (ANT/CABLE, VIDEO, etc.)
•
If ANT/CABLE is the current input, either "CABLE"
•
(for cable TV) or "ANT" (for over-the-air broadcasts).
Channel number (if in ANT/CABLE mode)
•
Channel label (if set)
•
Digital signal strength indicator (bar graph in lower
•
right corner of box; for ATSC signal only)
Stereo, Mono or SAP audio status (when HDMI input
•
mode, Dolby Digital or PCM)
46
Chapter 6: Using the TV's features
•
•
•
•
to
To close the RECALL screen:
Press
To display TV status information using INFO:
Press
The following additional information will display for
off air digital channels (if applicable):
.
•
•
•
.
Note: The location of the banner can be moved
to the top or bottom of the screen by pressing p
or q while the RECALL or INFO display is on-
screen.
Understanding the auto power off
feature
The TV will automatically turn itself off after
approximately 15 minutes if it is tuned to a vacant
channel or a station that completes its broadcast for the
day. This feature functions in ANT/CABLE mode only.
Understanding the last mode
memory feature
If the power is cut off while you are viewing the
TV, the Last Mode Memory feature automatically
turns on the TV when the power is resupplied.
Note: If it's possible, and you will be away
from the TV for an extended period of time you
should unplug the power cord.
Video resolution
Aspect ratio of incoming video signal (4:3 or 16:9)
V-Chip rating status
GameTimer (if set)
again.
on the remote control.
Title
Duration
Detailed description