TP-Link JetStream T2500G-10MPS Installation Manual page 9

10/100/1000Mbps RJ45 Port and PoE Port
Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or
1000Mbps. Each has a corresponding Speed or PoE LED.
SFP Port
Designed to install the SFP module. T2500G-10MPS features 2 SFP transceiver
ports.
Rear Panel
■
The rear panel of T2500G-10TS is shown as the following figure.
Figure 1-3 Rear Panel of T2500G-10TS
Kensington Security Slot
Grounding Terminal
Power Socket
Kensington Security Slot
Secure the lock (not provided) into the security slot to prevent the device from
being stolen.
Grounding Terminal
The switch already comes with lightning protection mechanism. You can also
ground the switch through the PE (Protecting Earth) cable of AC cord or with
Ground Cable. For detailed information, please refer to Chapter 3 Lightning
Protection.
Power Socket
Connect the female connector of the power cord here, and the male connector to
the AC power outlet. Please make sure the voltage of the power supply meets the
requirement of the input voltage (100-240V~ 50/60Hz).
The rear panel of T2500G-10MPS is shown as the following figure.
Figure 1-4 Rear Panel of T2500G-10MPS
Kensington Security Slot
Power Socket
Grounding Terminal
Kensington Security Slot
Secure the lock (not provided) into the security slot to prevent the device from
being stolen.
Gigabit L2 Managed Switch
Introduction
05