Starting A Cycle ( ); Interruption Of A Program; Changing A Program; Changing The Options - Electrolux EWF7554E3WB User Manual

5.4 Starting A Cycle (
To start a program, press the Start/Pause
touchpad. The corresponding pilot light
will stop flashing and a default program
duration will be displayed on the screen.
After approx. 15 minutes from the start of
a program:
- The appliance will automatically adjust
the selected program duration
according to the type and size of the
load.
-
The display will show adjusted
program duration.
NOTE
If you press any touchpad while a
program is operating, the symbol "
will flash on display along with buzzer
sound.

5.5 Interruption Of A Program

-
To pause, press Start/ Pause.
The indicator will start flashing.
-
Press the Start/Pause again.
The program will continue.

5.6 Changing A Program

Changing a running program is possible
only by resetting it.
-
Turn the program selector knob to the
position "Off" to cancel the program
and to turn off the appliance.
-
Turn the program selector knob to the
new program position and change any
available options. Press Start/Pause
to start the new program.
NOTE
The appliance will not drain the water
(except programs; Spin, Rinse + Spin).
)

5.7 Changing The Options

It may be possible to change some of the
options after a wash program has started.
Press the touchpad Start/Pause. The
1.
indicator will start flashing.
If available change the options that
2.
you wish.
Press Start/Pause again. The program
3.
will continue.

5.8 Opening The Door

While a program or the Delay End is
operating, the appliance door is locked
and the display shows the indicator "
First, set the machine to PAUSE by
pressing the "Start/Pause" touchpad. Wait
"
until the door lock indicator goes off, then
the door can be opened.
If the door lock indicator "
disappear, this means that the machine
is already heating and the water level is
above the bottom edge of the door or the
drum is turning. In this case the door
CAN NOT be opened. If you need to
open it, you must drain the water to open
the door.
In case of emergency please
refer to "Emergency door
opening" on page 30.

5.9 At The End Of The Program

-
The appliance stops automatically.
-
The acoustic signal will operate.
-
The display will show "
-
The indicator of the touchpad
Start/Pause goes off.
-
The door lock indicator "
-
Remove the laundry from the
appliance. Make sure that the drum is
empty.
-
Keep the door partly open, to prevent
the mildew and odours.
-
Turn off the water tap.
ENGLISH 19
19
ENGLISH
".
" does not
".
" goes off.