Samsung UE32J5100 E-Manual page 111

Setting up as an Anynet+ (HDMI-CEC)-enabled device
1.
SOURCE
Press the
then press the
2.
Anynet+ (HDMI-CEC)
Select
(HDMI-CEC)-enabled device. The following menu options are available.
"
The menu options available in the pop-up menu may differ with the external device.
Anynet+ (HDMI-CEC)
●
Sets up the selected device as an Anynet+ (HDMI-CEC)-enabled device and then displays a list
of Anynet+ (HDMI-CEC)-compliant devices connected to the TV. Select
(HDMI-CEC), and start watching TV.
Read before connecting an Anynet+ (HDMI-CEC)
"
You can configure the TV's universal remote control to control third-party cable boxes, Blu-ray players, and
home theatres that do not support HDMI-CEC. For more information, refer to "Controlling External Devices
with the TV Remote - Using the Universal Remote."
"
Anynet+ cannot be used to control external devices that do not support HDMI-CEC.
"
Anynet+ devices must be connected to the TV with an HDMI cable. Note that some HDMI cables may not
support Anynet+ (HDMI-CEC).
"
The TV remote control may not work under certain circumstances. If this occurs, select the Anynet+ device
again.
"
Anynet+ (HDMI-CEC) works only with external devices that support HDMI-CEC and only when those
devices are either in standby mode or turned on.
"
Anynet+ (HDMI-CEC) can control up to 12 compatible external devices (up to 3 of the same type). With
home theatre systems, however, the only one system can be controlled.
"
To listen to 5.1-channel audio from an external device, connect the device to the TV via an HDMI cable and
connect the home theatre system directly to the TV's digital audio output connector.
"
A home theatre system that has been connected to the TV with an HDMI cable and an optical cable only
supports 2-channel audio. 5.1-channel audio is, however, available for digital broadcasts with 5.1-channel
audio.
button on the remote control. On the
button.
from the
Source
Tools
list. The selected device is set up as an Anynet+
screen, select the device and
View TV
to exit Anynet+