Table of Contents
Advertisement
3 Get started
Charge your headphones
Warning
•
Only charge with a certified USB adapter
DC 5V/0.5A.
Note
•
Before you use your headphones for the
first time, charge the battery for 5 hours for
optimum battery capacity and lifetime.
•
Use only the original USB charging cable to
avoid any damage.
•
Finish your call before charging the
headphones, as connecting the headphones
for charging will power the headphones off.
Connect the supplied USB charging
cable to:
•
the micro USB charging slot on
the headphones and;
•
the certified charger/USB port
of a computer.
» LED turns red during charging
and turns off when the
headphones are fully charged.
Tip
•
Normally, a full charge takes 2 hours.
Pair the headphones
with your mobile phone
Before you use the headphones
with your mobile phone for the first
time, pair it with a mobile phone.
A successful pairing establishes a
4
EN
unique encrypted link between the
headphones and mobile phone. The
headphones store the last 4 devices
in the memory. If you try to pair more
than 4 devices, the earliest paired
device is replaced by the new one.
1
Make sure that the headphones
are fully charged and turned off.
2
Press and hold
until the blue and red LED flashes
alternately.
» The headphones remain in
pairing mode for 5 minutes.
3
Make sure that the mobile phone
is turned on and its Bluetooth
feature is activated.
4
Pair the headphones with the
mobile phone. For detailed
information, refer to the user
manual of your mobile phone.
The following example shows you
how to pair the headphones with your
mobile phone.
1
Activate the Bluetooth feature of
your mobile phone, select Philips
SHB4405.
2
Enter the headset password
"0000" (4 zeros) if prompted. For
those mobile phones featuring
Bluetooth 3.0 or higher, no need
to enter a password.
SHB4405
for 6 seconds
Advertisement
Table of Contents
