Contents 1 Important safety instructions Hearing Safety General information 2 Your Bluetooth wireless headphones What's in the box Other devices Overview of your Bluetooth wireless headphones 3 Get started Charge your headphones Pair the headphones with your mobile phone 4 Use your headphones Connect the headphones to a Bluetooth device Manage your calls and music...
1 Important safety General information instructions To avoid damage or malfunction: Caution • Do not expose headphones to excessive heat. • Hearing Safety Do not drop your headphones. • Headphones shall not be exposed to dripping or splashing. • Do not allow your headphones to be submerged in water.
Quick start guide Congratulations on your purchase, and Other devices welcome to Philips! To fully benefit from the support that Philips offers, register your product A mobile phone or device (e.g. notebook, PDA, at www.philips.com/welcome. Bluetooth adapters, MP3 players etc) which With this Philips wireless on-ear headphones,...
Page 6
g Volume/Track control h NFC detection area i Audio jack...
3 Get started There are two ways to pair your headphones with your mobile phone: • Manual pairing • NFC pairing Charge your headphones Manual pairing Note Make sure that the headphones are fully charged. • Before you use your headphones for the first time, Press and hold to turn the headphones charge the battery for 5 hours for optimum battery capacity and lifetime.
Page 8
The following example shows you how to pair the headphones with your mobile phone. Activate the Bluetooth feature of your mobile phone, select Philips SHB7250. Enter the headset password "0000" (4 zeros) if prompted. For those mobile phones featuring Bluetooth 3.0 or higher, no need to enter a password.
4 Use your Turn the Press and hold for 4 headphones seconds. headphones off. » The white LED is on and fades out. Connect the headphones to a Music control Bluetooth device Task Button Operation Play or pause Press once. Turn on your mobile phone/Bluetooth music.
Other headphones indicator status Headphones status Indicator • After use, twist the headphones for easy storage. The headphones The blue LED are connected to a flashes for every 8 Bluetooth device, while seconds. the headphones in standby mode or while you are listening to music.
5 Technical data • 11 hours of music time or talk time • 200 hours of standby time • Normal time for a full charge: 2 hours • Rechargeable Lithium-Polymer battery (200 mAh) • 3.5 mm audio jack for corded headphones mode •...
Hereby, WOOX Innovations declares that this product is in compliance with the essential requirements and other relevant provisions Remove the integrated battery of Directive 1999/5/EC. You can find the Declaration of Conformity on www.p4c.philips. Note com. • This product has been designed, tested and Make sure the headset is disconnected from the USB charging cable before removing the battery.
packaging materials, exhausted batteries and old equipment. Trademarks Bluetooth The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by WOOX Innovations Limited is under license. Siri is a trademark of Apple Inc., registered in the U.S.
7 Frequently The other side cannot hear me on the mobile phone. asked questions The microphone is muted. Press once to enable the microphone. My Bluetooth headphones are connected to a My Bluetooth headphones do not switch on. Bluetooth stereo enabled mobile phone, but The battery level is low.
Page 15
How can I restore all original headphones settings? When the headphones are powered on and is not connected to the USB cable, press and hold for 5 seconds until you see the white LED flashes 5 times.. For further support, visit www.philips.com/ support.