Table of Contents
Advertisement
Installation & User's Manual
Parameter
General
Power, Fan
Power-Up
Red Correct
Reset Hours
Set PIN
Presets
Protected
Load Factory
DMX
Address
Map
When no DMX
Display
Flip Display
Adj Contrast
Fixture
Fixture ID
Note: To Exit the Settings screen, use the [ESC] key. [ESC] and [OK] can be used to cancel or save changes to an
individual parameter. However, once a parameter has been accepted, by pressing [OK] that change cannot be undone/
canceled by pressing the [ESC] key.
2 0
OPERATION AND PROGRAMMING
Table 2: Settings Menu User-Settable Parameters
Values
Normal Mode (120W),
Studio Mode (80W), or
Normal Mode
Quiet Mode (60W)
All presets
Cool White
No / Yes
No, Yes
####
0 0 0 0 (four zeros)
No, 5 - 25
No, Yes
001 to 512
8-bit, 16-bit, or 5-Chan
Off, Hold, Hold 8Hr (8
hours), or No Output
No, Yes
0 - 100%
Shows Fixture Type - Profile, Cyc, or Fresnel
PLPROFILE1 MKII LED Luminaires
Default
Description
Sets the luminaire's output mode - Normal
Mode (120W), Studio Mode (80W) or
Quiet Mode (60W).
Users can set what the default preset is
when the unit is powered up. Factory
default is Cool White.
No
Turns on or off red correction.
No
Resets luminaire's operational hours.
A four-digit user-settable PIN code to lock
the fixture.
Determines if the factory Presets' Color
5 - 25
Mix is protected from changes.
Reload Factory Presets, Intensity changes
No
will also be reloaded.
DMX512 address. Note, it can be set if
001
displayed.
Defines size/precision of DMX map. Color
Mixing/Intensity in 16-bit provides higher
16-bit
resolution for precision control. 5-Chan
provides minimal channel usage.
If DMX is detected and then goes away,
this defines what will happen to the output.
Hold
At end of 8Hr hold Fixture goes to No
Output setting.
No
Flips (inverts) Display and Keypad Arrows.
Use left or right arrow keys to adjust
50%
display contrast as desired.
Shows luminaire type.
Advertisement
Table of Contents
