Using The Wall-Mounted Door Control - Chamberlain 3595C 3/4 HP Owner's Manual

Using the Wall-Mounted
Door Control
THE SMART CONTROL PANEL™
Press the push bar to
Motion Sensing
open or close the
door. Press again to
reverse the door
Prog <Learn>
during the closing
cycle or to stop the
door while it's
opening.
This door control
contains a motion
sensing detector that
Degrees (F/C)
will automatically turn
on the light when it
detects a person entering the garage.
Light feature
LIGHT
Press the Light button to turn the opener light on
or off. It will not control the opener lights when the door is
in motion. If you turn it on and then activate the opener, the
light will remain on for 4-1/2 minutes. Press again to turn it
off sooner. The 4-1/2 minute interval can be changed to 1-
1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold the
Lock button until the light blinks (about 10 seconds). A
single blink indicates that the timer is reset to 1-1/2
minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat again
for a 3-1/2 minute interval, etc., up to a maximum of four
blinks and 4-1/2 minutes.
When using the opener lights as working lights, we
recommend that you first disable the motion sensor. See
Automatic Light Feature, below.
Motion Sensing (Automatic Light Feature)
The opener light will turn on automatically when a person
enters the garage. When a person walks in front of the
door control, the light will come on for five minutes, then
shut off. This feature works by detecting body heat.
To disable this feature, push the motion sensing
button on the side of the door control.
We recommend that you disable the motion
sensor when using the opener lights as working lights.
Otherwise, they will turn off automatically if you are
working beyond the sensors range.
Lock feature
Designed to prevent operation of the door from
hand-held remote controls. However, the door will
LOCK
open and close from the Door Control, the Outdoor Key
Switch and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds.
To turn off, press and hold the Lock button again for
2 seconds. The Lock feature will also turn off whenever the
"learn" button on the motor unit panel is activated.
On/Off
Hour
Minute
L I G H
Language
L O C K
Lock Button
(PROG) Learn Feature
The door control is equipped with a PROG <LEARN>
button to assist in learning remote controls to the unit.
Press the PROG <LEARN> button once to initiate LEARN
mode and the display will show 'Learn Remote Control -
Push
Press Learn Button Again to Confirm.' Press the PROG
Bar
<LEARN> button a second time and the display will show
'Learn Mode - Press Remote Control Button to Learn
Remote.' Press the button of the remote control to be
learned and the worklight will blink to confirm the remote
control has been learned.
T
H M
Light
Button
increment the hour or minute displayed on the LCD
display.
(LANG) Language Feature
Press this side button to toggle between the three
languages - English, French and Spanish.
Degrees F/C Feature
Press this side button to toggle the temperature
units between Fahrenheit and Celsius.
Display Contrast Adjustment
Press and hold the light button then push the hour button
to increase the contrast or the minute button to decrease
the contrast.
24
Hour & Minute Feature
Press or hold either of these side buttons to