Installing Your Beverage Center; Cabinet Clearances - Marvel ML24BCG0RS Installation, Operation And Maintenance Instructions

Select Location
The proper location will ensure peak performance of your
beverage center. We recommend a location where the unit
will be out of direct sunlight and away from heat sources.
To ensure your product performs to specifications, the rec-
ommended installation location temperature range is from
55 to 100°F (13 to 38°C).
Cabinet Clearance
Ventilation is required from the bottom front of the beverage
center. Keep this area open and clear of any obstructions.
Adjacent cabinets and counter top can be installed around
the beverage center as long as the front grille remains
unobstructed.
WARNING
!
An optional stacking kit is required to stack products.
Failure to use a stacking kit could result in personal
injury. Contact your dealer or Marvel customer service
at 800-223-3900 to order.
CAUTION
!
Front Grille
Do not obstruct the front grille. The openings within the
front grille allow air to flow through the condenser heat ex-
changer. Restrictions to this air flow will result in increased
energy usage and loss of cooling capacity. For this reason
it is important this area not be obstructed and the grille
openings kept clean. Marvel does not recommend the use
of a custom made grille as air flow may be restricted. (See
Figure 2).

INSTALLING YOUR BEVERAGE CENTER

Front Leveling
Legs
Figure 2
Leveling Legs
Adjustable legs at the front and rear corners of the bever-
age center should be set so the unit is firmly positioned
on the floor and level from side to side and front to back.
The overall height of your Marvel beverage center may be
adjusted between the minimum, 33
the leveling leg in (CW ↷) and the maximum, 34
cm) by turning the leveling leg out (CCW ↶).
To adjust the leveling legs, place the beverage center on a
solid surface and protect the floor beneath the legs to avoid
scratching the floor. With the assistance of another person,
lean the beverage center back to access the front leveling
legs. Raise or lower the legs to the required dimension by
turning the legs. Repeat this process for the rear by tilt-
ing the beverage center forward using caution. On a level
surface check the beverage center for levelness and adjust
accordingly.
The front grille screws may be loosened and the grille ad-
justed to the desired height. When adjustment is complete
tighten the two front grille screws. (See Figure 5).
4
Front Grille,
keep this area
open.
Rear
Leveling
Legs
⁄ " (85.7 cm), by turning
3
4
⁄ " (88.3
3
4