Table of Contents
Advertisement
2. Pump grease into each fitting as follows:
•
For the pillow-block bearings, pump 1 shot of
grease into each fitting (Figure 32).
•
For the trunnions, pump several shots of grease
into each fitting until it starts to ooze out of the
bearing housing (Figure 32).
Important: Pump grease in slowly and carefully
to prevent damage to the bearing seals.
3. Wipe up any excess grease.
Lubricating the Motor Bearings
Service Interval: Every 6,000 hours
Grease type: electric-motor bearing grease
1. Clean around each grease fitting with a rag.
2. Pump 1 or 2 shots of grease into each fitting (Figure
33).
Important: Do not over-lubricate the motor.
3. Wipe up any excess grease.
Lubricating the Drive Chain
Service Interval: Every 40 hours—Lubricate the drive chain
with a non-sticky chain lubricant.
Apply a chain lubricant that is non-sticky to help prevent dirt
and abrasive particles from sticking to the chain.
G021588
Figure 33
1. Drive chain
23
1
G021584
Figure 34
Advertisement
Table of Contents
