Whirlpool WEG745H0FS Installation Instructions Manual page 12

4. Use a flat blade screwdriver (or other tool that fits your metal
clamp) to tighten the metal clamp and fix the hose on the
gas connection.
5. .Attach a metal clamp to the other edge of the hose and
connect this edge to the pressure regulator of your gas
cylinder. Tighten the metal clamp with the flat blade
screwdriver (or other tool that fits your metal clamp).
6. Make sure the gas valve is closed before connecting it to the
gas cylinder.
7. Make sure the hose is not folded or too close to heating
sources. Test all connections by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leak found.
12
Complete Connection
1. Check that the gas pressure regulator shut-off valve is in
the "on" position.
A. Gas pressure regulator shut-off
valve shown in the "on" position
2. Open the manual shut-off valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A
A. Closed valve
B. Open valve
3. Test all connections by brushing on an approved
noncorrosive leak-detection solution. If bubbles appear,
a leak is indicated. Correct any leak found.
A
B