Table of Contents
Advertisement
Recovering from no image
If monitors have no image after setting DP OUT MULTISTREAM, please set as follows:
1. Turn off the computer.
2. Touch the "MENU" key to show the No Signal OSD menu.
3. Touch the " " key to show VIDEO INPUT menu.
4. Touch the " " or " " key to show to set the DisplayPort switch menu.
5. Select DP VER "1.1" to switch the DisplayPort setting.
6. Press MENU to close the OSD menu.
7. Turn on the computer.
NOTE:
MST (multi-stream transport) and SST (single-stream transport) requires the corresponding display card.
Check to make sure that the display card supports MST (multi-stream transport).
(Please consult display card or system manual to change graphics mode.)
Contact your supplier for detailed information.
NOTE:
Monitors should be connected by the included DisplayPort cable.
English-28
Advertisement
Table of Contents
