Related Manuals for Golden Technologies MAXICOMFORT PR512MLA
Summary of Contents for Golden Technologies MAXICOMFORT PR512MLA
- Page 1 Power Lift & Recline Chair OWNER’S MANUAL MAXICOMFORT MODELS ™ PR630 PR512MLA 401 Bridge Street Old Forge, PA 18518 www.goldentech.com...
- Page 2 We hope that you enjoy years of pleasurable use of your Golden Technologies chair and that this chair becomes a true assist to you in both sitting down and standing up.
-
Page 3: Safety Guidelines
Safety Guidelines The symbols below are used in the owner’s manual and/or on the product to identify warnings and notify you of important safety information. Make sure you read and understand them completely. WARNING! Indicate(s) a hazardous situation which, if not avoided, could result in death or serious injury. - Page 4 continued from previous page Safety Guidelines Class II Device! Indoor use only! Do Not Smoke! Electrical hazard! Do not dispose in trash! Batteries required!
- Page 5 MANDATORY READ THIS MANUAL FIRST BEFORE INSTALLING OR OPERATING YOUR POWER LIFT AND RECLINE CHAIR. Your power lift and recline chair has been engineered from the leg levelers up to provide the ultimate in strength and reliability. Great care has been taken to provide you with total comfort and safety. Golden Technologies thoroughly inspects and tests each unit prior to shipment.
- Page 6 Do not operate the chair if there are any persons, pets or other obstructions under or in front of the footrest, under the chair or behind the chair. Do not smoke while operating, sitting or resting in the chair. To reduce risk of electrical shock, do not immerse any of the electrical components into a liquid, or spill any liquids onto electrical components.
- Page 7 INSTALLATION MAXICOMFORT MODELS 1. Remove the transformer from the transformer box (located behind the lower outside back) and install two 9 volt alkaline batteries into the sockets on the transformer. Place transformer on the floor behind the chair. 2. Plug the transformer into a 115-120V 60Hz A.C. outlet and connect the power cable from the chair into the transformer as shown.
- Page 8 aking ower onneCtions hair Model PR505-M26 1. Install two 9 volt alkaline batteries in the inline battery holder as shown. The battery holder is zip tied (white) to the rear of the metal frame. Cut the white zip tie and extend the cable under and out behind the chair. L.E.D.
- Page 9 rive ontroL Peration 1. Getting into your lift chair. While standing next to your chair, press button (S7) and raise the chair to a height you can sit against. This height will vary from person to person depending on the individual’s needs. Raise the chair high enough so you do not have to flop down into the chair.
-
Page 10: Factory Reset
1. Press and hold program button (SP). The back light goes off while pressed. 2. In about 3 seconds the backlight will start flashing (one flash) 3. Within 5 seconds, press one of the memory buttons (S5, S6, S8, S10) to save the position to the button pressed. - Page 11 Chair Operation Model PR505-M26 1. To recline the back of the chair, press button (S1) and hold until the back reaches the desired position. Then release the button. 2. To bring the back of the chair to an upright position, press button (S2) and hold until the back reaches the desired position.
- Page 12 and could cause personal injury. Press button (S3 or S5). As the chair continues downward, adjust yourself into a position that is comfortable to you. Continue holding button until chair is in the seated position (chair firmly on the floor), then release the button. Continue operating the chair with buttons S1 thru S6 until you reach your desired position.
- Page 13 rive ontroL Peration 1. Getting into your lift chair. While standing next to your chair, press button (S7) and raise the chair to a height you can sit against. This height will vary from person to person depending on the individual’s needs. Raise the chair high enough so you do not have to flop down into the chair.
- Page 14 Programming the Memory Buttons S8 and S10 Press one of the preprogrammed buttons (S8, S10) and hold until the chair stops. Press buttons (S1 thru S4) to micro adjust those positions to suit your needs. Use the following procedure to reprogram (S8, S10) buttons after you have the chair in your desired position.
-
Page 15: Battery Back Up System
Battery Back Up System Your Golden power lift chair comes with a battery back up system so the chair can return to the seated position in the event of a household power failure. The batteries have enough energy to bring the chair to a seated position from either recline or lift. - Page 16 MAXICOMFORT™ POSITIONS Your Golden power lift chair has been equipped with the MaxiComfort™ System. The MaxiComfort System has been designed specifically for you. Offering you a wide range of body positioning, so you can choose the position that best suits your needs.
-
Page 17: Care And Maintenance
CARE AND MAINTENANCE our lift chair will require routine maintenance checks. You can perform some of these checks, while others may require assistance from a provider. By following these maintenance checks, you can make sure your lift chair gives you years of trouble-free operation. If you have any questions or concerns regarding your lift chair’s care and maintenance, contact your provider. - Page 18 This warranty gives you specific legal rights, and you may also have other rights, which may vary from state to state. All warranty claims must be approved by Golden Technologies before any service is performed. Warranty is valid in all 50 states, Canadian Provinces and Puerto Rico.
- Page 19 otes...
- Page 20 otes...
- Page 23 Inquire about these fine mobility products also available from Golden Technologies f you’re looking for the perfect portable scooter loaded with style, look no further than the Buzzaround XL! Featuring a 300 lb. weight capacity, the Buzzaround XL disassembles quickly and easily.
-
Page 24: For Your Records
Your reCorDs Please fill in your Power Lift & Recline Chair information below. This information will be useful in the event that you should ever need to contact Golden Technologies, Inc. concerning your lift chair. Date of Purchase _____________________________________________ Model ______________________________________________________ Serial Number _______________________________________________ Your Golden Technologies, Inc.
Need help?
Do you have a question about the MAXICOMFORT PR512MLA and is the answer not in the manual?
Questions and answers