Installation - LG F1258RDS Series Owner's Manual

I nstallation
Install or store where it will not be exposed to temperatures below freezing or exposed to
the weather.
Properly ground washer to conform with all governing codes and ordinances.
The base opening must not be obstructed by carpeting when the washing machine is
installed on a carpeted floor.
In countries where there are areas which may be subject to infestation by cockroaches or
other vermin, pay particular attention to keeping the appliance and its surroundings in
clean condition at all times.
Any damage which may be cause by cockroaches or other vermin will not be covered by
the appliance guarantee.
Transit bolts
The appliance is fitted with transit bolts to prevent internal damage during transport.
• Packing and all transit bolts
must be removed before using
the washer.
When unpacking the base, be
sure to remove the additional
packing support in the middle
of the base packing.
Removing transit bolts
1. To prevent internal damage during
transport, the special 4 bolts are locked.
Before operating the washer, remove
the bolts along with the rubber bungs.
• If they are not removed, it may cause heavy
vibration, noise and malfunction.
2. Unscrew the 4 bolts with
the spanner supplied.
6
Washer
Base Packing
3. Take out the 4 bolts along with the rubber
bungs by slightly twisting the bung. Keep
the 4 bolts and the spanner for future use.
• Whenever the appliance is transported, the
transit bolts must be refitted.
4. Close the holes with the caps supplied.
Packing Support