Table of Contents
Advertisement
Product support
Help is always at hand
Troubleshooting
FAULT
The programme does not
start.
Water remains inside the
machine.
Machine stops
during washing.
Shaking and hitting noises are
heard during a wash operation.
Partial food wastes remain
on the dishes.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
35
Product support
POSSIBLE CAUSE
Your Dishwasher is not plugged in.
Your Dishwasher is not switched on.
Fuse blown.
Water inlet tap is closed.
Your Dishwasher door is open.
Water inlet hose and machine filters are
clogged.
Water drain hose is clogged or twisted.
The filters are clogged.
The programme is not finished yet.
Power failure.
Water inlet failure.
The spray arm is hitting the dishes in the
lower basket.
Dishes placed incorrectly, sprayed water not
reaching affected dishes.
Dishes leaning each another.
Not enough detergent used.
Wrong wash programme selected.
Spray arms clogged with food waste.
Filters or water drain pump clogged or
filter misplaced.
TROUBESHOOTING
Plug your Dishwasher in.
Switch your Dishwasher on by pressing the On/Off
button.
Check your indoor fuses.
Turn on the water inlet tap.
Close the Dishwasher door.
Check the water inlet hose and machine filters
and make sure they are not clogged.
Check the drain hose, then either clean or untwist it.
Clean the filters.
Wait until the programme is finished.
Check mains power.
Check water tap.
Move or remove items blocking the spray arm.
Do not overload baskets.
Place dishes as instructed in the section on loading your
dishwasher.
Use the correct amount of detergent, as instructed
in the programme table.
Use the information in the programme table to select
the most appropriate programme.
Clean the holes in the spray arms with thin objects.
Check the drain hose and filters are
correctly fitted.
Advertisement
Table of Contents
