Table of Contents
Advertisement
2
Remove debris.
3
Insert an anchor, tighten the screw, then
remove the screw to secure the anchor.
4
Insert the screw and tighten it.
2
Camera mounting stand
2
ALC (autoclaved lightweight cellular
concrete)
R Depending on the type of ALC panel, you
may not be able to attach the camera.
Consult the ALC panel manufacturer.
R Do not use the included screws. After
consulting the manufacturer of the ALC
panel, use only commercially-available
metal screw anchors (screw ø: 4 mm)
designed for ALC panels.
R Carefully read the instructions supplied with
the anchors. Follow instructions regarding
drill bit diameter, hole depth, etc.
R Drill a pilot hole. Remove any debris after
drilling the pilot hole.
R Seal the pilot hole with a
commercially-available waterproof sealant.
Other materials (mortar, tile, etc.)
R Do not use the included screws.
R Consult the builder or licenced professional
regarding the type of anchor appropriate for
the installation location and materials.
R Do not install on gypsum board or concrete
blocks.
Installing the camera
1
Attach the safety wire to the camera.
R Place the ring of the safety wire (A)
over the screw hole.
R Place a washer (B) on top of the ring
of the safety wire.
R Tighten the screw (C) for the safety
wire on top of the washer.
3
2
Attach the camera mounting stand to an
outdoor wall.
R Secure the stand to the wall by
tightening 4 screws (A).
R
37 mm
1
1
1
Setup
1
2
1
1
19
Advertisement
Table of Contents
