Installation Place Requirements - LG WTT02TLXMN Owner's Manual

Installation Place
Requirements
Location
135 cm
123 cm
2 cm
114 cm
*125 cm
10 cm
*125 cm: minimum space for installation
Level floor : Allowable slope under the entire
appliance is 1°.
Power outlet : Must be within 1.5 meters of
either side of the location of the appliance.
• Do not overload the outlet with more than one
appliance.
Additional Clearance : 5 cm at the sides and
10 cm behind the unit.
• Do not place or store laundry products on top
of the appliance at any time. These products
may damage the finish or controls.
WARNING
• The plug must be plugged into an appropriate
outlet that is properly installed and grounded
in accordance with all local codes and
ordinances.
Positioning
• Install the appliance on a flat hard floor.
• Make sure that air circulation around the
appliance is not impeded by carpets, rugs,
etc.
• Never try to correct any unevenness in the
floor with pieces of wood, cardboard or similar
materials under the appliance.
• If it is impossible to avoid positioning the
appliance next to a gas cooker or coal burning
stove, an insulation (85x60 cm) covered with
aluminum foil on the side facing the cooker or
stove must be inserted between the two
appliances.
12
• Do not install the appliance in rooms where
• Ensure that when the appliance is installed, it
0.5 cm
• With the appliance installed, adjust all four
125 cm
• If the appliance is delivered in winter and
60 cm
5 cm 5 cm
• Do not use a drip pan as it can block the
• This appliance is not designed for maritime
Electrical Connection
• Do not use an extension cord or double
• Always unplug the appliance and turn off the
• Connect the appliance to an earthed socket in
• The appliance must be positioned so that the
• Repairs to the appliance must only be carried
freezing temperatures may occur. Frozen
hoses may burst under pressure. The
reliability of the electronic control unit may be
impaired at temperatures below freezing point.
is easily accessible for an engineer in the
event of a breakdown.
feet using a transit bolt spanner to ensure the
appliance is stable, and a clearance of
approximately 5 mm is left between the top of
the appliance and the underside of any
work-top.
temperatures are below freezing, place the
appliance at room temperature for a few hours
before putting it into operation.
drawer. Using the drip pan may result in
increased vibration and noise during
operation.
WARNING
use or for use in mobile installations such as
caravans, aircraft etc.
adapter.
water supply after use.
accordance with current wiring regulations.
plug is easily accessible.
out by qualified personnel. Repairs carried out
by inexperienced persons may cause injury or
serious malfunctioning. Contact your local
service centre.
EN