Table of Contents
Advertisement
When done, mount the wall bracket on the wall.
There are two hinges(left and right). Use the correct one.
A -
Captive Screw
B -
Wall Bracket
C -
Hinge (Left)
D -
Hinge (Right)
2.
Before drilling into the wall, check if the length between the two locking holes at the back
of the product is correct.
If the length is too short or long, loosen all or some of the 4screws on the wall bracket to
adjust the length.
A -
Length between the two locking holes
3.
Check the installation diagram and mark the drill points on the wall. Use the 5.0 mm bit
to drill holes deeper than 35 mm. Fix each anchor in the corresponding hole. Match each
of the brackets and hinge holes to the corresponding anchor holes and insert and tighten
the 11 screws A.
Introduction
Advertisement
Table of Contents
