Advertisement
Do not insert any tool or foreign object into the valve outlet or safety relief valve. You may
damage the valve and cause a leak. Leaking propane may result in explosion, fire, severe
personal injury, or death.
Never attempt to attach this appliance to the self-contained LP gas system of a camper or trailer
or motor home.
The pressure regulator and hose assembly supplied with the appliance must be used.
Replacement pressure regulator and hose assemblies must be those specified by the appliance
manufacturer.
Do not use appliance until leak checked.
If leak is detected at any time, STOP.
If you cannot stop a gas leak, immediately close LP tank valve, leave area of appliance, and call
LP gas supplier or your fire department!
Leak Testing Valves, Hoses and Regulator
1. Turn all control knob(s) to OFF.
2. Be sure regulator is tightly connected to LP tanks.
3. Completely open LP tank valve by turning hand wheel counterclockwise. If you
hear a rushing sound, turn gas off immediately. There is a major leak at the
connection. Correct before proceeding.
4. Brush soapy solution onto indicated connections shown at right in A and B.
(Reference connection of hose to burner on page 11.)
5. If "growing" bubbles appear, there is a leak. Close LP tank valve immediately
and retighten connections. If leaks cannot be stopped, do no try to repair. Call
for replacement parts. Order new parts by giving the serial number, number and
name of items needed to the Customer Service Center at 1-888-837-1380. Use
only replacement parts specified by manufacturer.
6. Always close LP tank valve after performing tank test by turning hand wheel
clockwise.
Lighting Instructions
Do not lean over LP cooker while lighting.
1
Read instruction before lighting.
2
When you are sure there are no leaks, turn cylinder valve
and regulator control valve on hose to the closed position.
3
Reopen cylinder valve fully.
4
Have a standard match, fireplace match or long-nosed
propane lighter lit and ready to place over the burner.
5
Light the burner from the burner top before opening the gas
supply, keeping hands and face away from open burner.
6
Place lighter over the burner open, then slowly open
regulator valve until burner ignites.
7
Adjust the regulator control valve for desired flame height.
8
When finished using the cooker, turn off gas cylinder valve first. It will take a few second for the
fire to go out and for the propane gas to "bleed" from the hose and regulator assembly. After the
fire is completely out, turn regulator control valve to the"OFF" position.
To re-light, repeat steps 1 – 8. Always use CAUTION as cooker will be hot.
9
10 If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat
the lighting procedure.
TF1038-014531 English
WARNING
WARNING
7
B
05112018
Advertisement
