Fault
Creasing.
Detergent or fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
The spin result is not satis-
factory. The laundry is too
wet/too damp.
Detergent residue on the
damp washing.
Detergent residue on the dry
laundry.
Water is leaking out at the
water inlet hose.
Cause
The wrong programme is se-
lected for the type of fabric.
Too much detergent/fabric
softener in the detergent
drawer.
A low spin speed is selected.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
Unbalance load detection
system is using a reduced
spin speed to eliminate an
unbalance.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
Water inlet hose is not cor-
rectly/securely connected.
Troubleshooting en
Troubleshooting
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 24
When dosing liquid detergent and
▶
fabric softener, observe the mark-
ing in the detergent drawer and do
not dose above this.
The next time you run a wash cycle,
▶
set a higher spin speed.
Start the Schleudern programme.
▶
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Schleudern programme.
▶
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Schleudern programme.
▶
Start the Spülen programme.
▶
Brush out the laundry after washing
▶
and drying.
Connect the water supply hose cor-
1.
rectly. Connecting the water inlet
hose
Tighten the screw connection.
2.
49