Table of Contents
Advertisement
en Troubleshooting
Fault
The water is not draining.
Water is not flowing in. De-
tergent is not being dis-
pensed.
The spin cycle runs several
times.
46
Cause
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
Drain pump is blocked.
– –– is activated.
The water outlet hose is con-
nected too high.
Detergent dosage is too
high.
Unapproved extension in-
stalled on the water drain
hose.
You have not pressed Start/
Nachlegen.
The filter in the water inflow
is blocked.
The tap is turned off.
The water inlet hose is
kinked or jammed.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
Troubleshooting
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
→ "Cleaning the drain pump",
▶
Page 39
Continue the programme by select-
▶
ing Schleudern or Abpumpen and
pressing Start/Nachlegen.
→ "Resuming the programme when
the programme status is Rinse
Hold", Page 34
Install the water outlet hose at a
▶
maximum height of 1 metre.
Immediate measure: Mix one table-
▶
spoon of fabric softener with 0.5
litres of water and pour the mixture
into the left-hand compartment (not
for outdoor clothing, sportswear or
items stuffed with down).
Reduce the amount of detergent for
▶
the next washing cycle with the
same load.
Remove any unapproved exten-
▶
sions from the water hose. Connect-
ing the appliance
Press Start/Nachlegen.
▶
"Clean the water inflow filter"
▶
→ Page 42.
Turn on the tap.
▶
Ensure that the water inlet hose is
▶
not kinked or jammed.
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry
together in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Advertisement
Table of Contents
