Table of Contents
Advertisement
1
2
disconnect
Slide the hot shoe onto the camera accessory shoe
cable on the left hand side. If the housing is used with fiber optic strobes, the
hot shoe is not to be used and can then be disconnected from the connector
board located on the left side inside the housing (2).
Check the main housing O-ring (red 195*3 O-ring). This O-ring should be lay-
ing inside its groove and should be clean. No dirt, hairs or other substances
should be covering this O-ring. If necessary, clean this O-ring with micro fiber
cloth. Do not use cloth that produces fluff. As this is a static O-ring (which does
not move or rotate in relation to any other part) it doesn't need to be greased.
Set the photo/video mode selector on the housing
photo mode. The eyelet for the camera strap on the left hand side should be
flipped down, while the eyelet for the camera strap on the right hand side
should be flipped up.
Take the housing back shell with both hands and hold it over the front shell
containing the camera (5). The top side of the back shell should be about 3
cm over the top side of the front shell. Gently lower the top part of the back
shell while bringing it backwards (6). While bringing the back shell backwards,
5
6
3
4
photo
30°
(1)
keeping the ribbon
(3)
and camera
(4)
to the
7
make sure not to lift the top part of the back shell as this will also pull the hot
shoe backwards, disturbing the hot shoe connection (this will result in strobe
malfunction). Stop when the top parts of both shells are in line with each other
and are touching. Then gently lower the bottom part of the back shell until
both shells slide into one another (7). Make sure nothing gets between the two
shells when closing the housing (lanyards, ...).
Fasten the closing bolts with the Allen key supplied (8). Fasten both sides gradu-
ally and stop turning when the resistance on the Allen key increases signifi-
cantly. When the housing is fully closed, both shells will be in contact with each
other and no gap should be visible between them.
The housing is now closed.
Please check all camera functions before procee ding.
8
7
Hugyfot
User Manual HFN-D810
Advertisement
Table of Contents
