Motor Replacement - Hamilton Beach Commercial HMD0400 Operation Manual

Motor Replacement

Single Spindle Drink Mixer shown for illustration purposes.
Please follow the same procedure for Triple Spindle Drink Mixer.
wWARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts before operating.
Failure to do so can result in death
or electrical shock.
To replace the motor, follow the steps below, or call an authorized service center.
1. Unplug mixer.
2. Loosen the three
screws in the top
cover (the screws
will remain in the
cover). Lift off the
top cover and rest
against the rear
panel of the mixer.
3. Squeeze the tabs
on the sides of the
connector plug and
pull the two plug
halves apart.
4. Lift the motor/
agitator assembly
straight up and
out of the hous-
ing. Discard the
motor assembly in
an environmentally
acceptable
manner that complies with Federal, State and
local waste management regulations.
Care and Cleaning of the Mixer
Technical Services
For assistance or replacement parts, call
our Technical Services number:
866-285-1087 or + 910-693-4277
8:00 a.m. – 5:00 p.m. EST Monday – Friday
www.commercial.hamiltonbeach.com
5. Carefully lower the
new motor/agitator
assembly into the
housing, guiding the
spindle through the
hole in the housing.
Align the rounded
indent on the front of
the rubber support with the front screw boss in
the housing.
6. Plug the two halves
of the plug connector
together, ensuring
that all lead wire
colors match, and
tuck the connector
into the back of the housing. Make sure that the
side clips on the plug halves engage.
NOTE: The plug will only connect together
in one way.
7. Make sure that all wires are out of the way and
that they cannot come in contact with the motor.
Then lower the cover into place, making sure
that the upper tab and seal of the back panel are
in place below the lip of the cover. Secure the
cover with the screws.
8. Plug mixer into a grounded outlet.
7