Removing The Doors - Electrolux EW28BS87SS Use And Care Manual

Getting through narrow
spaces
If your refrigerator will not fit through an
entrance area, you can remove the doors.
Check first by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord
is unplugged from the wall outlet.
2 Open the freezer drawer and remove
the toe grille (see Installation section).
3 Remove any food from the door
shelves and close the doors.
To remove the top hinge covers:
1 Remove the two screws from each
cover over the top door hinges.
2 Lift inside edge of hinge cover and tilt back.
Front
Cover Screw
Top Hinge
Cover
Hinge
Screws
Multi-wire
Cables
Leave
Hinge
With
Door
Front
Rear
Cover Screw
Cover
Screw
Ground
Top
Screw
Hinge
NOTE
DO NOT remove the ground screw from hinge.

Removing the Doors

To remove the refrigerator doors
1 Trace lightly around the door's top
2 Disconnect the harness by grasping
Rear
Cover
Screw
Ground
Screw
Top
Hinge
Water
Line
3 Detach the water tube from the
Top Hinge
Cover
Hinge
Screws
Leave
Hinge
With
Door
Use care while pulling the water tube from the
unit to be sure that you do not kink the tube.
hinges with a pencil. This makes
reinstallation easier.
both sides of the connector firmly,
depress the latch, and pull apart.
Remove the two screws from the top
hinge. Lift the door off of the bottom
hinge and set it aside.
connector located behind the
refrigerator and pull the tube back out
to the front of the unit. The connector
releases when you press inward on
the outer sleeve while pushing the
tube toward the connector then while
continuing to hold in the sleeve, pull
the tube away.
NOTE
11