Stealth Cam STC-PX12K Instruction Manual page 10

CAMERA PROGRAMMING - CUSTOM (CONT)
RESOLUTION – (MED default): This setting is used to determine the megapixel resolution of each
image taken by the camera. This is only for PHOTO mode. With this option blinking, use the UP or
DOWN arrow key to move between the options of: 10MP(HI), 6MP(MED), 2MP(LO). The higher
the resolution of an image the more space the file will take on the SD memory card. Press the
ENTER button to accept all your changes and to go back to main options menu.
DELAY - (5SEC default): This setting is used to determine the length of time that the camera will
wait before it reinitializes its PIR sensor for the next activation. With this option blinking, use of
the UP and DOWN arrows to choice how many seconds you want the delay to be set for - 120S /
60S / 30S / 15S / 10S / 5S. Once this setting is on the appropriate time, press the ENTER button to
accept all your changes and to go back to main options menu.
BURST – (1P default): This setting is used to determine the number of photos the camera will take
during its activation. This setting can be changed between 1 PHOTO up to 6 PHOTOS. With this
option blinking, use the UP or DOWN arrow key to move between the value range in increments
of 1. Press the ENTER button to accept all your changes and to go back to main options menu.
VIDEO LENGTH – (15SEC default): This setting is used to determine the length of time, in seconds,
of the video recording. This setting can be set to either 30S / 15S / 5S. With this option blinking,
use the UP or DOWN arrow key to make your selection. Press the ENTER button to accept all your
changes and to go back to main options menu.
10
www.stealthcam.com Page
877-269-8490