Table of Contents
Advertisement
BEFORE USE
12
Method of mounting
The wall you select should be strong and solid
enough to prevent vibration.
1
Mount the installation plate on the wall
with type "A" screws. If mounting the unit
on a concrete wall, use anchor bolts.
- Mount the installation plate horizontally
by aligning the centerline using a level.
Installation Plate
Chassis
Hook
Type "A" screw
2
Measure the wall and mark the centerline.
It is also important to use caution concern-
ing the location of the installation plate
routing of the wiring to power outlets is
through the walls typically. Drilling the hole
through the wall for piping connections
must be done safely.
167
Unit Outline
C
Installation plate
A
Left rear piping
CHASSIS
(Grade)
A
SV
150
167
D
B
Right rear piping
Distance (mm)
B
C
D
140
43
43
3
Install after removing one of the indicated
cutting phase according to the installation
location of the indoor unit's piping.
Cutting Phase
4
Hook the indoor unit onto the upper por-
tion of the installation plate.( engage the
three hooks at the top of the indoor unit
with the upper edge of the installation
plate) Ensure that the hooks are properly
seated on the installation plate by moving
it left and right
2
Installation plate
5
Unlock the tubing holder from the chassis
and mount between the chassis and instal-
lation plate in order to separate the bottom
side of the indoor unit from the wall.
* The feature can be changed according to
the type of model.
1
ubing Holder
T
Advertisement
Table of Contents
