Controlling Audio; Speaker/ X'over Setup - Kenwood DDX9905S Instruction Manual

Controlling Audio

Controlling Audio
You can adjust various settings such as audio
balance or subwoofer level.
1
Press the [MENU] button.
h Popup menu appears.
h
2
Touch [Audio].
See the following section for each
setting.
• Set up speaker/ X'over (P.78)
• Controlling equalizer (P.80)
• Set listening position/ DTA (P.83)
• Controlling general audio (Fader /
Balance) (P.79)
• Set volume offset (P.81)
• Performing zone control (P.81)
• Set sound effect (P.82)
• Memory/recall the audio settings
(P.84)
78

Speaker/ X'over setup

1
Press the [MENU] button.
h Popup menu appears. h
2
Touch [Audio].
h Audio screen appears. h
3
Touch [Speaker/Xʼover].
4
Select a car type.
You can select the car type and speaker
network, etc.
When you select your car type, the Delay
Time Alignment is activated automatically
(for timing adjustment of sound output for
each channel) to have the highest surround
effects.
5
Touch the speaker (1) you wish to adjust
and set each parameter (2) as follows.
1
■ [Speaker]
You can select a speaker type and its size to
get the best sound effects.
When the speaker type and size are selected,
the speaker crossover network is set
automatically.
[Location] (Only for Front, Rear)
■
Select the speaker position you have
installed.
2