Startup; Cabinet Air-Flow - True TFP-48-18M-D-4 Installation Manual

True Food Service Equipment, Inc.

STARTUP

A. The compressor is ready to operate. Plug in the
cooler.
B. Temperature control set at No. 4 position gives
refrigerators an approximate temperature of 35°F.
Allow unit to function several hours, completely
cooling cabinet before changing the control setting.
C. Excessive tampering with the control could lead to
service difficulties. Should it ever become necessary
to replace temperature control, be sure it is ordered
from your TRUE dealer or recommended service
agent.
D. Good air flow in your TRUE unit is critical. Be
careful to load product so that it neither presses
against the back wall, nor comes within four inches
of the evaporator housing. Refrigerated air off the
coil must circulate down the back wall.
AIR-FLOW THROUGHOUT CABINET
WARNING
REMOVAL OF BAFFLES IN CONDIMENT PAN AREA WILL
ADVERSELY AFFECT REFRIGERATION PERFORMANCE.
PLEASE LEAVE THE BAFFLES IN THE CORRECT LOCATION.
(See images below)
11
INSTALLATION / OPERATION INSTRUCTIONS
Baffle in the correct location.
............ www.truemfg.com ............
NOTE
If the cooler is disconnected or shut off, wait five minutes
before starting again.
RECOMMENDATION
Before loading product we recommend you run your TRUE
unit empty for two to three days. This allows you to be sure
electrical wiring and installation are correct and no shipping
damage has occurred. Remember, our factory warranty
does not cover product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number for
your cooler. If at any time during the life of your cooler, a
part is needed, you may obtain this part by furnishing the
model number and serial number to the company from
whom you purchased the cooler. Call Toll-Free: (800)-424-
TRUE (Direct to Parts Department). (800)-325-6152 (U.S.A.
& Canada only) or call: (636)-240-2400.
(TPP UNITS ONLY!)
11