Using The Wall-Mounted Door Control; To Open The Door Manually - Chamberlain 2565 Owner's Manual

Chamberlain garage door opener 2565 owner's manual
Hide thumbs Also See for 2565:
Table of Contents

Advertisement

Using the Wall-Mounted
Door Control
THE PASSIVE INFRARED
CONTROL CONSOLE
Press the push bar to open or
close the door. Press again to
reverse the door during the
closing cycle or to stop the
door while it's opening.
This door control contains a
motion detector that will
automatically turn on the light
when it detects a person entering the garage. This
feature can be easily turned off for extended work
light use.
Light feature
Press the Light button to turn the opener light on or
off. It will not control the opener lights when the door
is in motion. If you turn it on and then activate the
opener, the light will remain on for 4-1/2 minutes.
Press again to turn it off sooner.
The 4-1/2 minute interval can be changed to 1-1/2,
2-1/2, or 3-1/2 minutes as follows: Press and hold the
Lock button until the light blinks (about 10 seconds).
A single blink indicates that the timer is reset to 1-1/2
minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat
again for a 3-1/2 minute interval, etc., up to a
maximum of four blinks and 4-1/2 minutes.
When using the opener lights as working lights, we
recommend that you first disable the motion sensor.
See Automatic Light Feature, following.
• Automatic Light Feature: The opener light will
turn on automatically when a person enters the
garage. When a person walks in front of the door
control, the light will come on for five minutes, then
shut off. This feature works by detecting body heat
and may not work in temperatures around 100˚F.
To disable this feature, slide the Detector Switch on
the right side of the door control down (off).
We recommend that you disable the motion sensor
when using the opener lights as working lights.
Otherwise, they will turn off automatically if you are
working beyond the sensor's range.
Lock feature
Designed to prevent operation of the door from hand-
held remote controls. However, the door will open
and close from the Door Control, the Outdoor Key
Switch and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2
seconds. The push bar indicator light will flash as
long as the Lock feature is on.
To turn off, press and hold the Lock button again for
2 seconds. The push bar light will stop flashing. The
Lock feature will also turn off whenever the learn
button on the motor unit panel is activated.
Push
Bar
Detector
Switch
Lock
Light
Button
Push
Button
Bar
D
S
Lock
Light
Button
Button
28
Additional feature when used with the
3-function hand-held remote
To control the opener lights:
In addition to operating the door, you
may program the remote to operate the lights.
1. With the door closed, press and hold a small
remote button that you want to control the light.
2. Press and hold the Light button on the door
control.
3. While holding the Light button, press and hold the
Lock button on the door control.
4. After the opener lights flash, release all buttons.

To Open the Door Manually

WARNING
• To prevent possible SERIOUS INJURY or DEATH from
a falling garage door:
– If possible, use emergency release handle to
disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.
– NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If rope
knot becomes untied, you could fall.
The door should be fully
closed if possible. Pull down
on the emergency release
handle and lift the door
manually. To reconnect the
door to the opener, press
the door control push bar.
The lockout feature
prevents the trolley from
reconnecting automatically,
Pull the emergency release
handle down and back
(toward the opener). The
door can then be raised and
lowered manually as often
as necessary. To disengage
the lockout feature, pull the
handle straight down. The
trolley will reconnect on the
next UP or DOWN
operation.
Trolley
Release
Emergency
Arm
Release
Handle
(Pull Down)
MANUAL DISCONNECT
POSITION
Trolley
Release
Arm
Emergency
Release Handle
(Pull Down & Back
Towards Opener)
LOCKOUT POSITION

Advertisement

Table of Contents
loading

This manual is also suitable for:

Liftmaster security+ 2565 1/2hp

Table of Contents