Table of Contents
Advertisement
Available languages
Available languages
When changing the filter please note:
1. If you wish to replace exhaust filter a
with filter b, c or d, it is essential that
you remove the filter grille before you
fit the new exhaust filter.
You must also activate the exhaust
filter change indicator (dia. 12).
2. If you wish to replace exhaust filter b,
c or d with filter a, it is essential that
you also fit the filter grille * (dia. 32).
* Filter grille - see "Optional ac-
cessories".
When to change the thread lifters
The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.
How to replace the thread lifters
(dia. 35)
Use a suitable screwdriver to remove
the thread lifters from the slots.
Fit new thread lifters.
Cleaning the roller on the AllTeQ
floorhead (dia. 36)
Release the bearing (with bayonet fit-
ting) using a coin.
Press the bearing out, and remove.
Remove the roller.
Remove any threads and hair, replace
the roller and refit the bearing, locking
it back into position.
Replacement parts are available from
your Miele Dealer or from Miele (see
end of booklet for contact details).
Cleaning and care
Always disconnect the vacuum
cleaner from the electrical supply be-
fore cleaning it. Switch off at the wall
socket and unplug it.
Vacuum cleaner and accessories
The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for plastic.
Do not use abrasive cleaning
agents, glass cleaning agents, all-
purpose cleaners or oil-based condi-
tioning agents.
Dust compartment
The dust compartment can, if neces-
sary, be cleaned using a dry duster,
brush or, if available, a second vacuum
cleaner to vacuum the dust out.
Do not let the vacuum cleaner
get wet. If moisture gets into the ap-
pliance, there is a risk of electric
shock.
en
45
Advertisement
Chapters
Table of Contents
