Replacing One Type Of Exhaust Filter With Another; When Changing The Filter Please Note; Maintenance Indicator With Reset Button; Inserting Batteries Into The Led Handle - Miele SGDE0 Operating Instructions Manual

Replacing one type of exhaust filter
with another (Fig. 09)
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters :
a AirClean
b Active AirClean 50 (black)
c HEPA AirClean 50 (white)
Do not use more than one exhaust fil-
ter at a time.

When changing the filter please note

1. If you wish to replace exhaust filter a
with filter b or c, you must com-
pletely remove the filter grille before
you install the new exhaust filter. You
must also activate the TimeStrip®
exhaust filter change in-dicator (Fig.
12).
2. If you wish to replace exhaust filter b
or c with filter a, you must insert the
new filter into a filter grille * before
in-stalling (Fig. 38).
* Filter grille – see "Optional acces-
sories"
Maintenance indicator with reset
but-ton (Fig. 41)
Some models are fitted with a mainte-
nance indicator.
The indicator lights up after approxi-
mately 50 hours of operation, which is
equivalent to about a year of average
use. The level of soiling of the motor
protection filter and the exhaust filter
must be checked at this point.
The indicator must be reset each time
the filters are replaced. The vacuum
cleaner must be switched on to do this.
 Press the reset button.
The maintenance indicator will go out
and reset to zero.
The indicator can only be reset by
pressing the reset button after the
light has come on. Pressing the but-
ton at any other time will have no ef-
fect.
Inserting batteries into the LED han-
dle (Figs. 15 + 16)
(depending on model)
You will need three 1.5 V (AAA) batter-
ies.
 Loosen the screws on the cover.
 Press down on both sides of the
cover to remove it.
 Take out the battery holder and in-
sert the three batteries supplied
making sure the polarity is correct.
 Replace the battery holder. Make
sure the arrows on the holder and in
the battery compartment line up in
the same direction.
 Replace the cover and tighten the
screw.
en-US
23