KingShield Orion Range OD105 Quick Start Manual

Infra-red motion sensor - ceiling mounted

Infra-red Motion Sensor - Ceiling Mounted

•

Please read these instructions carefully before installation and keep safe for future reference.

IMPORTANT

This product should be installed by a competent person and in accordance with the current

IET Wiring Regulations and Building Regulations.

If in doubt,consult a qualified electrician.

•

Always turn off the mains supply before commencing work.

As the detector responds to changes in temperature, avoid the following situations:-

•

Avoid pointing the detector towards objects with highly reflective surfaces, such as mirrors

etc.

•

Avoid mounting the detector near heat sources, such as heating vents, air conditioning

units, lights etc.

•

Avoid pointing the detector towards objects that may move in the wind, such as curtains,

tall plants etc.

Switch the mains supply OFF first to prevent electric shock.

1. Decide on mounting position of sensor in ceiling, and cut a 65mm hole, (ensure there is no

wiring/gas/water services directly behind the screws) Dia:1.

Dia:1

'Orion Range'

Model: OD105

Important Safety Instructions

FIELD OF DETECTION

Table of Contents

Do you have a question about the Orion Range OD105 and is the answer not in the manual?

Page 1 ‘Orion Range’ Infra-red Motion Sensor - Ceiling Mounted Model: OD105 Important Safety Instructions • Please read these instructions carefully before installation and keep safe for future reference. IMPORTANT This product should be installed by a competent person and in accordance with the current IET Wiring Regulations and Building Regulations.
Page 2 2. Connect wiring in accordance with Dia:2. Dia:2 3. Fold the metal springs of the sensor upwards and insert into the installation hole releasing springs, the springs will hold sensor in position. 4. To access the lux and time controls, insert a small flat-bladed screwdriver into the open release slot and twist, pull down until the controls are showing.