Siemens SN277W01TG Instruction Manual page 45

Fault
Plastic parts discoloured.
Removable streaks on
glasses, glasses with
metallic appearance and
cutlery.
Initial or existing,
irreversible clouding of
glass.
Rust spots on the cutlery.
Cause
Too low rinsing temperature.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Too much rinse aid.
No rinse aid added or setting too
low.
Detergent residue in the final
rinse programme section.
Detergent dispenser cover
blocked by utensils (cover does
not open fully).
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Glasses not dishwasher-proof,
only suitable for dishwasher.
Cutlery not adequately
rust-resistant. Knife blades are
frequently more severely
affected.
Cutlery will also rust if rusting
parts are rinsed at the same time
(pan handles, damaged utensil
baskets, etc.).
Salt content in the rinsing water
too high, as salt dispenser lock
not fastened firmly or salt was
spilled while being refilled.
Fault, what to do? en
Remedial action
Select programme with higher washing
temperature.
Do not prerinse utensils. Remove only
large food remnants.
Increase sensitivity of the sensors.
~ "Sensor setting" on page 31
Recommended programme Eco 50°
Set rinse aid amount to lower setting.
Add rinse aid and check dosage
(recommended setting 4–5).
Detergent dispenser cover must not be
obstructed by utensils.
Do not place utensils or fragrance
dispenser in the tablet collecting tray.
Do not prerinse utensils. Remove only
large food remnants.
Increase sensitivity of the sensors.
~ "Sensor setting" on page 31
Recommended programme Eco 50°
Use dishwasher-proof glasses.
Avoid long steam phase (standing time
after wash cycle ends).
Use wash cycle at lower temperature.
Set water softening system according to
the water hardness (if required one setting
lower).
Use detergent with glass protection
component.
Use rust-resistant cutlery.
Do not wash rusting parts.
Fasten salt dispenser lock firmly or
remove spilled salt.
45