Table of Contents
Advertisement
Top up the salt as follows:
Undo the screw plug on the
1.
dispenser 1R.
Fill the dispenser with water
2.
(required only when switching on the
appliance for the first time).
Add salt as illustrated (do not use
3.
table salt or tablets).
The water is displaced and runs out.
* depending on the features of your
dishwasher
Using detergents with salt
component
If combined detergents with a salt
s a l t c o m p o n e n t
D e t e r g e n t w i t h a
component are used, special salt can
usually be omitted up to a water
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l). If the water
hardness is over 21° dH, salt must be
used.
Switching off low salt
indicator / water softening
system
If the use of combined detergents with a
s t e m
t e r s o f t e n i n g s y
S w i t c h i n g o f f w a
salt component impairs the low salt
indicator P on the control panel or
the text on the display window at the
top @ (enough salt for x rinse cycles),
the displays can be switched off.
Proceed as described under "Setting
water softening system" and set the
value to 0-8. The water softening system
and salt refill indicator are now switched
off.
,
Rinse aid
As soon as the low rinse-aid indicator
R i n s e a i d
H is lit on the control panel or is
requested on the front display * ):,
rinse-aid should be topped up.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26°
Clarke, 3.7 mmol/l) only. If the water
hardness is over 21° dH, rinse-aid must
be used.
* depending on the features of your
dishwasher
Rinse aid en
17
Advertisement
Table of Contents
